Crossbow and Bow?

Bow = Crossbow, or not?


It has repeatedly appears in filamentous questions about crossbows and why it is not involved in the debate on hunting with bow and arrow. To make a simple explanation for this, I write the following.


Certainly fire a crossbow, an arrow, or as it is called a bolt, and much the same principle as a bow, or a bow with a string, but this ends igentligen difference.
The crossbow was a further development of the bow when there was a need (in war) to obtain a Weapons more suited for close combat, and could pierce armor. It was probably a medelitida further development ensuring bonded all branches even today, it was simply bow features and compressed them into a smaller weapon. When looking for a Stronger permeation in armor had become the weapon more powerful than a bow and more easily injected.



They did crossbow so heavily to tighten the need for a tire winch of some sort, the first type could tighten by hand but by the time they were equipped with a spännvev.Modern crossbow has cartridges arrow. such but there are variations where you have to use your own packed cylindrical to tighten arrows.

This also means that a crossbow can be loaded and preloaded unlike a bow and the soldier could thus firing his bolt faster than an archer. However, only the first arrow bolt, it took longer for a crossbow shooter to reload than an arc shooter.

Crossbow was not designed for hunting, but only in ancient military purposes.

Today's crossbow is more like a rifle than a bow, that they have a piston stock as a gunpowder weapons, and equipped with such telescopic sights. To shoot with a crossbow is nothing like shooting with a bow in terms of technology, the ballistic properties is just as if you look at the arrow's characteristics. A bolt has some minor drawbacks because it is short
Half as long as an arrow, or even shorter. This affects the aerodynamic characteristics
At the arrow bolt and has a slightly slimmer precision than a long arrow.

Does it work for hunting?

Certainly, the clinical effect of a crossbow bolt is fully adequate and equal to an arrow from a bow. It is widely used in the U.S. crossbow for huntung the same good results as bow hunting.

Bow hunting is so much more, here is a shooting technique and form so much more important that it is tantamount to shooting with crossbows and why is it so that the bow-hunters are not crossbow hunters, certainly pushes secure several with crossbows, but it is not the same .

In order to allow hunting with crossbows in some country, would need more work behind the crossbow.
Is a licensed weapon. And in many parts of Europe are bonded crossbow banned for hunting.

So the answer is, No. crossbow is a bow!

TenPoint Carbon Fusion CLS Crossbow AcuDraw Pkg

TenPoint Carbon Fusion CLS Crossbow AcuDraw Pkg



TenPoint`s Compact Limb System Technology in Authentic Carbon Weave 20 oz`s lighter from top to bottom of this crossbow with the ACUDraw crank system installed on the industry`s first floating woven carbon fiber barrel to produce a whisper quiet, vibration-free shot, integrated one piece aluminum riser and foot stirrup, FST camo thumbhole style stock has molded cavity for storage of crank (models without ACUdraw are fitted with a rubber insert) , 12 Iso Taper camo limbs equipped with MR cams, D75 string and cables with tunable yokes, 3.5 lb power touch trigger, anti-dry fire button, ambidextrous automatic safety, patented grip safety secondary safety on fore-grip hand (left-hand installation available a special order item)
- Draw weight: 185 lb.
- Power stroke: 13
- Mass weight: 7lb. 3oz.( bow only)
- Length:(with stirrup) 38 1/2
- Width: 20 1/2
- Speed: 345 fps
- Kinetic Energy: 111 ft lbs.
- Arrow length 20.

*All bows are weighed without accessories - ACUdraw 50 weight = 12 oz., ACUdraw weight = 1 lb. 3 oz., RangeMaster Pro Scope = 13.25 oz. & 3x Pro-View 2 Scope = 10.95 oz.
**All crossbows were tested with 20” 22/64ths carbon fiber shafts with 4” vanes, brass inserts, SuperBrite™ nocks, and 100-grain tips (each 420-grains).

Package Includes

- Rangemaster Pro scope
- 7/8 fixed dovetail mount
- SteedyEddy monopod
- TenPoint Bowjax noise dampening kit
- Airline approved compact travel & storage case
- grip-guard safety shield
- 6pk of Pro Elite carbon fiber arrows w/ SuperBrite blunt nocks and practice points
- deluxe 4-arrow HX quiver
- TenPoint Staff shooter field hat
- instructional DVD
- vehicle window sticker.


We keep finding that without a doubt, the best place to buy them is Amazon.com.  They have in stock can ship immediately and have the best prices anywhere on the internet. You can find that Amazon also will be at most outdoors stores for similar products and will often times ship for free or at a drastically discounted price.  Probably the best feature about buying from Amazon is that you’ll have the ability to read honest reviews from other customers who have purchased the products already.  This gives you a tremendous advantage from a consumer perspective regarding information about the quality of the products making your purchasing

Shipping Information: (View shipping rates and policies)



Customer Reviews
By..Cox ,December 19, 2011 on Amazon.com
This carbon fusion is my first crossbow. I am very impressed! The quality is excellent and the bow shoots great. It is exactly as described. I'm looking forward to taking advantage of the long archery season.

The Old Article Book "Hunter’s Crossbow"

Hunter’s Crossbow

Build a Hunter’s Crossbow (Dec, 1953)

Source: Mechanix Illustrated ( More articles from this issue )
Issue: Dec, 1953

Buy on Amazon.com

 




    This old-time weapon has the hitting power and accuracy of a modern rifle.

    By E. Milton Grassell

    THIS crossbow, with all the romance and charm of a medieval weapon, is so powerful and accurate that it is used extensively for hunting and precision target shooting. It’s a deadly weapon, not a toy, exceptionally fine for hunting rabbits, pheasants, squirrels, and even capable of killing big game like deer, elk, antelope, and cougar when used by one skilled in its handling. Therefore it is most imperative that the crossbow be handled carefully. Never hold it in a position where it might endanger anyone if fired accidently, and always reckon with the area beyond the target or game in the event you should miss hitting the object aimed at.
    A similar crossbow would cost from $50 up commercially, but the total cost, if you make it, should not exceed $7.50, providing there are a few scrap hardwood pieces, a dab of lacquer, welding rod and some other common materials around your workshop.

    Sold on making one? Okay, here’s how Mr. Chester Stevenson of Eugene, Ore., makes his most popularly demanded crossbow, and how you, too, can become a jet-age Robin Hood with this powerful weapon.

    On crossbows, the “barrel” is included in the stock piece. If you don’t have a hardwood board about 1-1/2x8x36-in., glue scrap pieces together. This works just as well. In fact, the whole design can be modified, providing the draw (14-in. from the back of the bow to the trigger release latch) and the trigger unit are not altered. Follow the drawings and you’ll have no trouble making any parts of the crossbow.

    After cutting the general contour, a recess is chiseled in the stock for the trigger assembly. Between this and the end of the barrel, make a kerf (a bolt groove) approximately 3/16×1/2-in. deep down the center. Sandpaper is used to make the 1/8in. chamfer on both edges of the bolt groove.

    The unique trigger, modified by Mr. Stevenson, will fire the bolt with approximately the same finger pressure used to shoot an ordinary rifle, when the release latch is cocked with a 75-pound pressure.

    The trigger guard, made from No. 16 gauge brass, 1/2×6-in., is bent and fastened with three No. 6 half-inch roundhead brass screws.

    When hunting, you will probably aim along the bolt, but sights are preferable for target shooting. The peep sight shown in the photos, made from 1/2xlxl-in. brass scrap, is extremely precise, yet it can be made with three drills (1/64, 1/8 and 5/8-in.), a hacksaw and a file. It has both vertical and horizontal adjustments which are held with lock screws (see drawing).

    The bow attachment assembly is the weakest part of the stock assembly. Therefore, two 3/8-in. thick strips are used to reinforce this area. You can machine the required combination screw-bolts, and the fancy knurled lock nuts, but it’s simpler to buy two closet screws from the neighborhood plumber.

    There are two other parts to this unit—a wedge-shaped block, and the bow lock plate, used to hold the bow securely in place.

    The bow has two unusual features: (1) the 1/4x2x36-in. solid stave (either yew wood or osage orange), and the Fiberglas, when cut according to plan, requires no tillering, and’ (2) the reverse curve gives added speed. That’s the reason this crossbow has jet-like power.

    Don’t let the steaming and reverse curve bending worry you. It’s really simple, as the photos show. You can make a steam pot from old brake drums and a piece of pipe, as shown in drawing. The strap metal bending jig is also easy to make.

    Take the measurement of the finished bow from nock to nock and order a bow string from an archery supply firm. Today, archery supply houses also sell arrow shafts, piles (points), ground feathers, and other accessories that practically reduce bolt making to an assembling arid finishing job.

    Order several 5/16-in. straight 30-in. shafts. Since bolts are shorter than long bow arrows, these can be cut so as to make two bolts from each shaft.

    If you purchase slip-over type points, no tenon is necessary on the shaft. This further simplifies bolt making.

    Before fletching the shaft, finish it with dipping or brushing lacquer. Never use varnish on target bolts. Friction causes the shaft to heat when it penetrates straw targets and the varnish blisters.

    Either right or left wing turkey feathers can be used, providing they are the same on any one arrow. The feathers can be trimmed with scissors. Place them in a fletching jig (these sell from $1.50 up with directions included) and glue them on the shaft with household cement. When fletching shafts with broadhead points, be sure the cock feather and the vertical surface of the broad-head are in the same plane. (See drawing.) The nock, customarily found on arrows, is not used on bolts. Nothing is done to the rear of the shaft. Before you load the crossbow with a bolt, try cocking it a few times, as shown in photo, until you have developed a real feel for the job.


credit : http://blog.modernmechanix.com/2006/08/01/build-a-hunters-crossbow/

Horton Summit HD 150 Target Practice

Horton Summit HD 150 Target Practice Video Clips.
Duration : 3.05 Mins.


PENETRATION OUTDOORS
Tags: Horton, Summit, Target, hunting, crossbow, rage, archery

How to Shoot a Bow Correctly-Proper Archery Technique

Archery is a fantastic hobby to devote your time to. It is a skill you can enjoy using your entire life, whether in your backyard or a professional tournament. It is important for you to learn the basics and get started on the right track.

Start by picking up your bow, a good 20 yards from your target. Several beginners tend to want to hold the bow with their good hand, and use their off hand to pull back the string. That is not correct. Assuming you are right handed, use your left hand to hold the bow and your right to pull back the string.

Crossbow For Hunting

Before you notch an arrow, you need to get into a proper shooting stance. Place your feet about shoulder width apart, your front foot should face the target. Make your back foot perpendicular to the target, and then turn it forwardslightly so it ends up at about a 70 degree angle (almost facing sideways, but a little bit forward). Your stance should be similar to the stance of a batter in baseball, except, your body will be facing slightly more forward. Finally, make small little tweaks so that you are comfortable and relaxed.

Now pick up the arrow, and get ready to fire. Your bow probably has a small bead or mark somewhere close to the center of the string. If so, use it by notching the arrow on top of it. If you don't see anything on your string, just the arrow notch at the center. Moving on, your bow probably also has a nice spot on the bow to rest the shaft of your arrow. Once again, use this if you have it.

How to Shoot a Bow Correctly-Proper Archery Technique

Afterward, it is time to begin pulling the string of the bow back. Remember, use your stronghand to pull the string, off hand to hold the bow. Put two fingers beneath the arrow (ring and middle finger) and put your index finger above the arrow. Slightly squeeze your fingers on the arrow to keep it steady, and simultaneously pull back the string. Pull back as far as you can, and prepare to aim.

I probably should have mentioned this earlier, but if you look at your arrow you will see that it has three feathers. One of these will be a different color than the other two, and this one should be different on top. With the string pulled pack, hold the bow up to your face, and look right down the arrow. First, make your line of sight go right to the center of the target. Then, raise the bow just a little so you are aiming just above the bulls-eye.

Finally, the climax moment,releasing the arrow. Slowly relieve your fingers of your hand, string and allow them to let the string slip out. Congratulations! You just took a shot fired, with proper form. Repeat this process for all your arrows.

Tips: I recommend you wear a forearm band, because when you release the string it might hit the forearm of the hand holding the bow. Also, you may want to put a few haystacks behind your target so you don't end up retrieving arrows a mile away. Finally, just remember to keep practicing. You will get better!

How to Shoot a Bow Correctly-Proper Archery Technique